Skip to main content

FLY-ALPS Firmware Flashing

Applicable Versions

This documentation applies to devices with firmware versions below v2.0.0. If your firmware version is at or above this version, please refer to the Firmware Update documentation for direct updates via the web tool, without needing to enter DFU mode.

Check Firmware Version​

You can check the current firmware version number after connecting the device via the Web Tool.

Firmware Download​

The firmware can be obtained via the following links:

Enter Flashing Mode (for Flashing BOOT Firmware)​

You can make the device enter flashing mode using any of the following methods:

  • Method 1:

    1. Connect the device to your computer using a Type-C cable.
    2. Press and hold the BOOT button on the device, briefly press the RESET button, then release BOOT.

  • Method 2:

    1. Press and hold the BOOT button on the device.
    2. Connect the Type-C cable to the device and computer, then release the BOOT button.
Loading...

Flash Complete Firmware​

The FLY-ALPS firmware is located at the following path within the archive:

FLY-Firmware/ExtensionBoard/ALPS/mergedBL

For the general flashing method, please refer to the following link:

Update Firmware: Please See This Link

Note

Do not disconnect the Type-C connection during the flashing process, as this may cause the flashing to fail.

Next Steps​

After flashing the BOOT firmware, the device supports direct updates of the main firmware via the web tool, without needing to enter DFU mode again.

Please refer to the Firmware Update documentation to complete the main firmware update.

Loading...