Skip to main content

Halo Page Operation Introduction

Page Structure​

  Print Files Page         Home             Extrude Page        Sys Service         Setting          Dev Info
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
|             |    |             |    |             |    |             |    |             |    |             |
| Print Files |<-->|     Home    |<-->|   Extrude   |<-->| Sys Service |<-->|   Setting   |<-->|  Dev Info   |
|             |    |             |    |             |    |             |    |             |    |             |
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
                         ∧
                         |
                         ∨
                   +-------------+
                   |             |
                   | Blocking Det|
                   |             |
                   +-------------+
                   Clog Detection Page
            (This page appears only when clog detection is enabled in settings)

Home Page​

Loading...
Loading...
  • The operable areas in Figure 1 above correspond to the numbers below
  1. Click: Enter the extrusion temperature setting, adjust the temperature by dragging the ring slider, click area 1 again to confirm the set temperature
  2. Click: Enter the hotbed temperature setting, adjust the temperature by dragging the ring slider, click area 2 again to confirm the set temperature

Extrusion Page​

Loading...
Loading...
  • The operable areas in Figure 1 above correspond to the numbers below
  1. Single tap: increase the extruder head target temperature by 1
  2. Long press: enter extrusion temperature settings, adjust the temperature by dragging the ring-shaped bar, and single tap again to confirm the temperature setting
  3. Single tap: decrease the extruder head target temperature by 1
  4. Single tap: extrude
  5. Swipe up and down: select the length for extrusion or retraction, unit: mm
  6. Single tap: retract
  7. Long press: enter the extrusion speed settings as shown in Figure 2 above, swipe up and down to select the extrusion speed, unit: mm/s, after selecting, single tap an empty area nearby to exit

System Service Page​

Loading...
Loading...
  • Click the corresponding service in Figure 1 above to display the popup in Figure 2, allowing you to start, restart, or stop the corresponding system service
  • Future OTA updates will support all services that Moonraker can operate

Setting Page​

  • To be updated
Loading...