Skip to main content

BL Firmware

tip
  • Please note that the bootloader is pre-flashed at the factory and does not need to be re-flashed.

Entering Flash Mode​

  • There are two methods to enter flash mode.
  • First method: With the mainboard completely powered off, press and hold the BOOT button, then connect a data cable capable of data transfer between the mainboard and your device. Suitable for WINDOWS.
  • Second method: After connecting a data cable capable of data transfer between the mainboard and your device, press and hold the BOOT button, then enter the command. Suitable for the host computer.
    Loading...

Flashing Firmware​

  • C8 bootloader firmware

    • Click the download link below.
    • Loading...

  • Set DIP switches 3 and 4 to the right side to connect the lower computer to the host computer via the built-in USB.

  • Set DIP switches 1 and 2 to the left side, otherwise it will affect the connection between the lower computer and the host computer.

    Loading...
Important Notice

To ensure successful STM32 flashing, please pay attention to the following:

  • Some computer USB ports may have driver or signal compatibility issues, leading to unstable flashing. It is recommended that you try connecting to a different USB port.
  • If changing ports does not work, an effective solution is to connect via an external USB hub, which often improves compatibility.
  • When the flashing software reports the error message shown below, also try using a hub first. If the problem persists, please check or use the host computer software for flashing.
    Loading...
  1. Flashing Tool Download Link
  2. Download SetupSTM32CubeProgrammer and the STM32 DFU Driver.
  3. Download the firmware to any directory on your computer.
  4. Connect the mainboard to the computer using a Type-C cable. Ensure it has entered DFU flashing mode.
  5. In STM32CubeProgrammer, select USB mode, refresh, and connect.
    Loading...
  6. If no error pop-up appears, the connection is successful.
    Loading...
  7. Click the download icon on the left and select the options shown below.
    Loading...
  8. Click the Browse button indicated by the arrow, then select the firmware you need to flash.
    Loading...
  9. For Start address, enter 0x08000000.
    • Note: If the firmware is in HEX format, please skip this step!!
    Loading...
  10. Click Start automatic mode below to begin flashing the firmware.
    Loading...
  11. The prompt below indicates that the firmware flashing is complete.
    Loading...
Loading...