Introduction
Product Features
Firmware Update
* The device comes pre-flashed with firmware from the factory.
Connect to WiFi
* The onboard antenna of this product can only be used for receiving. The transmitting antenna needs to be installed by yourself. The antenna terminal is ipex3.
Connect to Klipper
* AirClick must be connected to the same network as the target printer.
Connect to RRF
* AirClick must be connected to the same network as the target printer.
Connect to BambuLab
* AirClick must be connected to the same network as the target printer
Button Addition
* The wireless button requires a battery to be installed. The battery model is CR927.
Wired Connection Klipper Configuration
* The STM32F072 must be flashed with firmware and connected to Klipper; otherwise, wired connection operation is not supported.
D Models
AirClick 3D Model