install

Installation Guide

Installing to Voron Stealthburner

• Installing Halo to Stealthburner requires the adapter we provide
• First download the model we provide for printing
  • Click the download link below
• Loading...

Antenna Installation

Loading...

Loading...

FPC Installation

• Install the FPC cable as shown in the figure below (do not install the FPC cable in the wrong direction, the blue side should face up)

Loading...

Loading...

Mounting Bracket Installation

Loading...

Loading...

Loading...

Loading...

Route the FPC through the cable hole as shown in the figure below

Loading...

Loading...

As shown in Figure 1 below, first align the lower clips, then press in the upper part. Figure 2 below shows the installed result

Loading...

Loading...

Install the Adapter Board and Connection Cable

• The cable exit position can be arranged according to your preference, it does not have to be attached to the back of the fan

Loading...

Notes

• Cable color description: Black is negative GND, Red is positive VCC, acceptable voltage is DC12-24V, White is GPIO47, can be used for filament runout detection, Yellow is GPIO48, can be used for shutdown after printing completion

Installation on Filament Detection

• Pending update