Introduction

FLY C8P

Uses STM32H723VGT6 main control chip from the Arm® Cortex®-M7 series with a 32-bit main frequency of 550MHz
Supports SPI and UART operation modes of TMC drivers
Onboard DIAG function pin allows unlimited homing by simply plugging/unplugging a jumper cap
Selectable 24V, 12V, or 5V voltage for the CNC fan, eliminating the need to purchase a buck module
New Flash programming method allows firmware updates directly via command line
Multiple power management circuits ensure that short circuits on ports, limit switches, or drivers won't affect the host computer's operation
Reserved RGB interface supports selectable voltage (12V or 5V)
Supports one-cable connectivity for TFT and HDMI displays
Pre-installed system software includes klipper, moonraker, mainsail, fulidd, klipper-screen, Crowsnest, and resonance compensation plugin numpy, no need for source switching, easier for beginners to get started

CPU: Allwinner H618, Quad-core 64-bit Cortex-A53
GPU: Arm Mali-G31
RAM: 1GB DDR4
ROM: Supports up to 128GB SD card
Peripherals:
- TFT x1
- USB 2.0 x2
- Micro HDMI x1
- Ethernet port (Eth) x1 (100M)
- FPC-HDMI x1
- UART x1
- RS232 x2
Interfaces: Onboard M.2 for expansion of WIFI, eMMC, etc. (uses a proprietary protocol; do not connect non-FLY M.2 devices)
Supports: One-cable connectivity for TFT and HDMI FPC displays
Pre-installed System: klipper, moonraker, mainsail, fulidd, klipper-screen, Crowsnest, resonance compensation plugin numpy, no need to switch sources, easy to use (TF card or M2WE must be purchased separately)

MCU: STM32H723VGT6
Firmware: KLIPPER/RRF
Supports 12-24V DC power supply for more stable power, eliminating the need for a buck module
Maximum output current for heated bed port: 15A
Maximum output current for heater port: 6A
Maximum output current for fan port: 1A
Supported driver operation modes: SPI, UART, STEP/DIR
Supported drivers: External TMC5160Pro, TMC5160, TMC2209, TMC2225, TMC2226, TMC2208, TMC2130, A4988, etc.
Expansion interfaces: BLTouch (Servos, Probe), RGB x2, UART x1, 12864 x1, CAN x1
Fans: 6 two-wire CNC fans (supports 24V, 12V, or 5V) with optional voltage
Temperature sensors: 4 channels of NTC 100K
Supported machine structures: Cartesian, Delta, Kossel, Ultimaker, CoreXY, etc.