Connecting to the Host via SSH

Danger

This documentation applies only to FLY devices with an onboard host.
If you are compiling or flashing firmware, please refer to the network connection tutorial rather than the serial port connection tutorial.

You can connect to the device via serial port or WIFI.
Please prepare MobaXterm_Personal or another SSH terminal tool in advance.
Please ensure that the system has been flashed to the SD card or M2WE for the corresponding host.
If the host fails to boot normally, first power off and remove peripherals such as drivers, endstops, and fans before troubleshooting.
For firmware compilation, it is recommended to connect to the host's SSH via WIFI or an Ethernet cable.

Installing the System Storage Card

Ensure the system card has the corresponding system flashed; otherwise, it will not boot.

After connecting the host to the computer via USB, click Device Connection below
If everything is normal, USB Serial or other similar devices will be displayed
Select the corresponding device, then click Connect
After a successful connection, a prompt will appear
FlyOS-FAST default username root, default password mellow
Starting from version V1.3.2, the FAST system automatically logs in when using a serial connection by double-clicking or pressing Enter twice consecutively
After pressing Enter, the content shown in the figure below will appear

Loading...

Tip

If the host is properly connected to the computer, open Device Manager and you will see the CH340 port

Open MobaXterm and configure as follows. For the port, select the port you saw earlier in Device Manager

If after waiting a few minutes, the interface shows nothing as in the figure below, just press Enter a few times

FlyOS-FAST default username root, default password mellow
Starting from version V1.3.2, the FAST system automatically logs in when using a serial connection by double-clicking or pressing Enter twice consecutively
After pressing Enter, the content shown in the figure below will appear

Loading...

Tip

If you need to view the device IP, make sure a network cable or Wi-Fi is connected Connect WIFI

Please log in to the router admin panel that the host is connected to, unless you know the host IP address
Please make sure you know the host username and password
FlyOS-FAST default username root, default password mellow
If the motherboard has already started and is connected to the network, you can use the following method to connect to SSH
Open MobaXterm and configure as follows. For IP, enter the one you checked earlier, or you can also check it in the router admin panel

Note: In step 4 here, enter the host username

You will be prompted to enter the password. Enter the host password and press Enter

Note: The password entered here is invisible, just press Enter after entering it

Tip